Keeping You Updated With Our
Future Software Development Leads Discussion at May Advisory Board MeetingJune 1, 2009
On May 14 and 15, the Advisory Board met at Design Data headquarters in Lincoln, Nebraska, to discuss the upcoming release of SDS/2 v7.2, as well as future software expansion.
"Overall, the meeting went very well," said Stephanie Haith, Design Data's QA manager. "We were able to gain a lot of feedback on current and future software development, and resolved outstanding questions with the help of Advisory Board members."
Advisory Board Chairman Luis Torres agrees. "The meeting was very productive. Both the Advisory Board and Design Data were on the same page, and I look forward to the final release of 7.2."
Among the new features in SDS/2 v7.2 are:
- IFC Import
- DWF Import
- Embed Plates
- Anchor Rods
- Image Support
- Symbol Support
- P2 Export
- Never reuse submaterial piecemarks
- Custom properties defaults loaded on creation of job
- Erection view section cuts
- Weld paths
- Isolate submaterial
- Bill of Material Editor changes
- Enhanced member model complete
- Drawing by reference